PA1 Speaker not broadcasting : Helpdesk platform

C

Chris Ferrall

started a topic 10 months ago

I have a brand new PA1 that is not broadcasting out the speaker. I hear the IP address if I press the IP/Reset button but no pages. I have multicast relay enabled and that is working. Casing speaker is enabled as is the speaker under PA1 controls.

Best Answer

C

Chris Ferrall said 10 months ago

I found it. Preferences\Use Headset Device -> RJ Connector. That activated the speaker for some reason.

C

Catalina Moritz

said 10 months ago

Hi Chris, this might help: http://wiki.snom.com/FAQ/Why_do_I_not_hear_the_announcment_coming_out_of_my_PA1_speaker%3F

C

Chris Ferrall

said 10 months ago

There is no pull down menu in the Auto Answer section, just an on/off selection.

The unit has firmware 8.7.3.19

C

Catalina Moritz

said 10 months ago

Please also try the second part and set headset_active=on

C

Chris Ferrall

said 10 months ago

Answer

I found it. Preferences\Use Headset Device -> RJ Connector. That activated the speaker for some reason.

M

Mike Ledbetter

said 6 months ago

I have an issue that once connected to the PBX (Sangoma UC25) the following log of errors occurs

Snom PA1 Logs show this:
26/11/2019 14:00:48 [FATAL ] LID: LLDP: No Voice Application Type TLV packet found!
26/11/2019 14:01:18 [FATAL ] LID: LLDP: No Voice Application Type TLV packet found!
26/11/2019 14:01:49 [FATAL ] LID: LLDP: No Voice Application Type TLV packet found!
26/11/2019 14:02:19 [FATAL ] LID: LLDP: No Voice Application Type TLV packet found!
26/11/2019 14:02:49 [FATAL ] LID: LLDP: No Voice Application Type TLV packet found!
26/11/2019 14:02:59 [NOTICE] PHN: TPL: Socket 105 idle/connect timeout
26/11/2019 14:03:03 [NOTICE] PHN: TPL: Socket 104 idle/connect timeout
26/11/2019 14:03:07 [NOTICE] PHN: TPL: Socket 106 idle/connect timeout
26/11/2019 14:03:08 [NOTICE] PHN: TPL: Socket 107 idle/connect timeout

Any ideas?