Route Voice Traffic over one out ouf three M700 Base Stations
H
Heinz Busch
started a topic
about 3 years ago
Hello,
we are using three M700 as DECT base stations to cover our building. Since these are behind NAT, we would like to route or kind of "tunnel" all voice traffic over one single station, so that the others just work as providers for roaming functions. We could then expose the local IP address of this station to the WAN. Is that possible?
Thanks in advance!
Best Answer
S
Sync Account
said
almost 3 years ago
Dear Heinz,
unfortunately this is not possible, or better can be possible if you have only max 8 narrowband calls on the whole system.
1 Comment
S
Sync Account
said
almost 3 years ago
Answer
Dear Heinz,
unfortunately this is not possible, or better can be possible if you have only max 8 narrowband calls on the whole system.
Heinz Busch
Hello,
we are using three M700 as DECT base stations to cover our building. Since these are behind NAT, we would like to route or kind of "tunnel" all voice traffic over one single station, so that the others just work as providers for roaming functions. We could then expose the local IP address of this station to the WAN. Is that possible?
Thanks in advance!
Dear Heinz,
unfortunately this is not possible, or better can be possible if you have only max 8 narrowband calls on the whole system.
Sync Account
Dear Heinz,
unfortunately this is not possible, or better can be possible if you have only max 8 narrowband calls on the whole system.
-
Firmware Update Error
-
Snom FW 8.7.3.25 / Snom 720
-
Hold, then direct transfer
-
M325 blinking orange light on base station
-
Importing Device Certificate on DECT M300
-
CTI client for Snom M65
-
Snom M700 M65 and FreePBX
-
Snom m9r and 3CX
-
Need Firmware 323.11
-
Getting 3CX Directory onto Snom M9r Phone
See all 231 topics